SKU: 91098305894

Lemon RX LM0086XT60 DSMP 7ch RX Telemetry, Stabilizer & Energy Meter

Sale price$37.80 Regular price$42.00
Save 10%

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 10 - Jul 15

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

Lemon RX LM0086XT60 DSMP 7ch RX Telemetry, Stabilizer & Energy MeterThe generation 2 DSMP 7 channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance. DSMX DSM2 compatible, 7 channel full range telemetry stabilizer with full telemetry features including a built in barometer, altimeter, energy meter (Current, Voltage, mAh), and internal temperature sensor High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both

The generation 2 DSMP 7-channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance.

- DSMX / DSM2 compatible, 7-channel full-range telemetry stabilizer with full telemetry features including a built-in barometer, altimeter, energy meter (Current, Voltage, mAh),  and internal temperature sensor
- High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both electric and gasoline engine application
- BEC1 and BEC2 dual inputs allow high-reliability operation while improving setup for high current drain performance servo
- Built-in Delta, V-tail and Normal Wing mixer
- Supports stabilization with separated channel dual aileron operation
- Stabilization always-on feature
- Real-time variable stabilization gain control on channel 8
- All-channel failsafe
- Firmware health monitoring software stack and ultra-low operational voltage (3.6V) ensure the highest hardware reliability
- Generation 2 SDR stack ensures the fastest channel searching and advanced algorithm for signal recovery with ultra-low-latency experience
- Antenna diversity improves the reliability of the wireless link 
- Satellite port for additional signal diversity
- Gyro stabilization activation with either AUX2 or Gear channel
- 3 potentiometers for individual gain tuning

User manual
- See www.lemon-rx.com/manual

Quick Reference Guide
Reset stabilizer
- Connect power
- Hold F and B buttons (approximately 5 secs+) until all LED flashes randomly
- Press the C button. Multiple LEDs flash a few times to complete the operation

Bind with bind plug
- Insert bind plug on Channel 7
- Connect power

Bind without bind plug
- Connect power
- Hold the B button until the red LED flashes
 
Bind with a satellite without a bind plug
- Connect power
- Hold the B button until the red LED flashes
- Disconnect power
- Plug the satellite wire connector into the stabilizer
- Connect power

Failsafe
- Connect power to the receiver and ensure the servos are working with the transmitter
- Press the F button for 3 seconds until green changes from off to on and vice versa to change the failsafe setting. Channel value is saved as failsafe default at the time the green LED turns on. 
- Turn off the transmitter and wait 2 seconds to ensure the failsafe is activated accordingly by ensuring there is torque generated with finger-pushing the servo linkage if it was to be set. Vice versa.

Stabilization activation switch
- Disconnect power
- Insert bind plug to channel 5
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash.
- Release the C button
- Press C to make changes within 3 seconds. Green = CH7, Blue = CH5.
- Wait for 3 seconds and remove the bind plug

Wing Mode and Dual Aileron
- Disconnect power
- Insert bind plug to channel 6
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash
- Check the receiver label/user manual to understand the referred LEDs' operation 
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug
- Ensure transmitter mixing is set accordingly for dual aileron if stabilized dual aileron is to be configured.

Gyro direction
- Check the receiver  label/user manual to understand the referred LEDs' operation
- Connect power and wait 1 second 
- Hold the C button and wait for about 1 second until the 6 LEDs flash
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug.

V/I sensor calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected. 
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Turn on the DC loading device by throttling the transmitter. Ensure 4A is drawing across the V/I sensor. Be careful with the motor spinning if it is to be used.
- Press the B button to save and exit.

V/I probe calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected. 
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Press the B button to save and exit.

Gain setting
- Adjust via the 3 dials or real-time master gain on channel 8 depending on the transmitter channel's availability.
 
View setting LEDs with all on
- Press the C button briefly (no more than 2 seconds).

Lemon Rx products are tested to be compatible with Spektrum's DSMX and or DSM2 product (Spektrum, DSMX and DSM2 are the registered trademark of Horizon Hobby, Inc.).


Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 91098305894

Discover Niche Categories That Outsell

Top-Converting Item to Boost Your Average Order

4.9 ★★★★★
Based on 2457 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
A
Verified Purchase
Amazon Junkie
Lowell, US
★★★★★ 5
Great golf shirt!
Size: Small, Color: White/Light Blue Stripe
My son loves this shirt! It has silky smooth wrinkle-fabric and is nice and cool on the golf course. It is true to size, hangs well (no clinging) and allows full range of movement. It washes great! I wash and dry in the machine and stains come right out.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 29, 2025
D
Verified Purchase
Dawn
Port Orchard, US
★★★★★ 5
Beautiful colors, nice golf shirt
Size: XX-Large, Color: Aqua Blue Stripe
I always read reviews before I purchase and this golf shirt had positive ones. I ordered one so I could see the fit (true to size), and see how it laundered. Both are a thumbs up from me. Beautiful vibrant color, at a price comparable or less than what you might find in store. The SPF protection is a plus. I will be ordering more.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 20, 2026
K
Verified Purchase
KentBaxter
Boise, US
★★★★★ 3
Golf shirt
Size: Large, Color: Aqua Blue Stripe
I like the shirt is comfortable, but I thought the ad said three of them and Allie got one. Haven’t looked to see how much I paid for it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 10, 2025
F
Verified Purchase
Frequent Customer
Draper, US
★★★★★ 5
I like these fleece-lined pants
Color: Black, Size: 32W x 32L
For these specific pants, the 32" inseam is accurate and fits as expected. The fleece lining was great in high 40's and did not feel too warm when the temp climbed into the 60's. I was impressed enough to buy a second pair. They appear to be well made and look great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 10, 2026
K
Verified Purchase
Kevin Ervin
Draper, US
★★★★★ 5
Perfect. Warmth without bulk
Color: Grey, Size: 34W x 30L
Perfect thickness and insulation level. Warmth without bulk. Stylish and do a good job disguising what they are. Cut is similar to "regular" or "straight" cut jeans. Will be ordering other colors...
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 13, 2026

recommand products