Hondata 4 Port Boost Control Solenoid

Hondata 4 Port Boost Control SolenoidThe Hondata 4 port boost controller precisely directs pressure to the top and bottom of your waste gate diaphragm. It allows much lower waste gate spring pressure for better low gear boost control and perfect high gear, high boost control. A 10 lb waste gate spring will enable 50+ psi of boost Better spool up and mid range power Better duty cycle control For use with: S300 K Pro FlashPro 2006 11 Civic Si FlashPro S2000 FlashPro 07 08 TSX The Hondata 4

The Hondata 4 port boost controller precisely directs pressure to the top and bottom of your waste-gate diaphragm. It allows much lower waste-gate spring pressure for better low gear boost control and perfect high gear, high boost control.

• A 10 lb waste-gate spring will enable 50+ psi of boost
• Better spool-up and mid range power
• Better duty cycle control

For use with:

• S300
• K-Pro
• FlashPro 2006-11 Civic Si
• FlashPro S2000
• FlashPro 07/08 TSX

The Hondata 4 port boost control solenoid is designed for use in high boost applications, but also works well in low boost applications. It is normally closed so that on failure you will run off the waste-gate spring to prevent over-boosting.  It uses 1/8th NPT fittings which can be adapted to AN fittings.

If you are upgrading from a 3 port solenoid, the boost control tables will need re-tuning.

Download PDF install instructions